7 Easy Steps to Make a Beer Bong

What you’ll need: (all of these items can be found at a local hardware store)

  • (1) large funnel.

  • (1)- 2 & 1/2 foot clear vinyl tubing, 1 inch x 3/4 inch (1 inch = diameter of the outside of tubing, 3/4 inch = diameter of inside of tubing)

  • (1) 3/4 inch PVC ball valve (threaded)

  • (1) 3/4 inch x 3 inch  PVC nipple (male to male threaded)

  • (1) 3/4 inch Barb x 3/4 inch MPT poly adapter (male threaded)

  • (2) 1 & 1/4 inch hose clamps  

  • (1) Flat-Head screwdriver

Materials needed.JPG

Step 1: Take your clear vinyl tubing and slip it onto the bottom spout of your large funnel. If your funnel’s spout is long then cut some off to shorten it ( this will reduce beer foam). A good length for the spout is 1 inch.  

step 1.gif

Step 2: Take one of your hose clamps and slip it where it fits around the tubing on the funnel’s spout. Then tighten the clamp with your flat head screwdriver.  

Step 2_gif.gif

Step 3: Take your 3/4 inch PVC ball valve and screw the 3/4 inch x 3 inch PVC nipple on one side.

step 3_gif.gif

Step 4: Take your 3/4 inch Barb x 3/4 inch MPT poly adapter and screw it into the other side of the PVC ball valve.

step 4_gif..gif

Step 5: Slip the other hose clamp on the end of the tubing. Don’t tighten it yet.

step 5.gif

Step 6: Push the barbed end of the poly adapter into the tubing. Make sure it’s in all the way. Then slip the hose clamp onto the end of the tube where the barb is underneath.

step 6.gif

Step 7: Now tighten the hose clamp.


There you have it, a homemade professional beer bong! Remember to please drink responsibly.   


Shop Daily Dropout